Thanks for sharing your print. The glossy finish on top looks really nice. Did you print on a heated glass plattform or did you use a buildtak print surface?
Hi, this was printed on a PEI surface on my P3steel, heated to 60 degrees (though the PETG will adhere well to PEI even without heating the bed). PETG in both the solid and transparent filaments of 3Dprima has a good looking sheen to it and is my preferred filament to print with. It tends to ooze and blob a bit more than PLA or ABS and it doesn't sand as nicely either, but usually very little cleanup is needed. I'll post another photo when it's mounted to the Kossel Mini. Again, thanks for your designs, I'll probably print your extruder next. (y)
Thanks for sharing your print. The glossy finish on top looks really nice. Did you print on a heated glass plattform or did you use a buildtak print surface?
Hi, this was printed on a PEI surface on my P3steel, heated to 60 degrees (though the PETG will adhere well to PEI even without heating the bed). PETG in both the solid and transparent filaments of 3Dprima has a good looking sheen to it and is my preferred filament to print with. It tends to ooze and blob a bit more than PLA or ABS and it doesn't sand as nicely either, but usually very little cleanup is needed. I'll post another photo when it's mounted to the Kossel Mini. Again, thanks for your designs, I'll probably print your extruder next. (y)