I flipped the model so that the base was build plate side down. This is one time I should not have walked away from the print.(See picture #1)
After I replaced the extruders, I tried again and the model would not stick to build plate, (changed filaments, settings, etc.). Tried a different model and it printed just fine.Found out rock base bottom is not completely flat and that was why it kept coming loose. I turned on supports and that filled the gaps, the model stuck and it printed like a champ.
Kryptonite-Maker Geeks Crystal Series PLA Red
Rock Base- eSun Black PLA
Gray Blob-3D Solutech Gray PLA