This is a very well done model with excellent directions and tips! The parts went together with very little fitting. All parts were printed in black PLA. The base was sprayed in gray primer and then hand painted the colors with acrylic paints. I chose not to use the textured spray paint as directions called out. The white strips were laid out with regular masking tape cut into 3/8" wide strips and then spray painted. To curl the railing and light cage I heated the printer bed to 100 C and used it to warm the parts. I then rolled the parts around a piece of wood dowel that was just a little smaller than the finished diameter of each part. The parts cool very quickly when removed from the heated bed, so I did the rolling and forming right on the bed. I also designed and printed a few additional parts to add a white LED light to the model.
0.2mm and 0.1 for the roof