Loading

Prusa i3 PSU Cover + Switch

Made by Gr8andPowerful1, uploaded

Prusa i3 PSU Cover + Switch Made by Gr8andPowerful1 May 18, 2017

Source

Prusa i3 PSU Cover + Switch by oliasmage Nov 3, 2014

Description

So really the switch box needs to be about 1/2in deeper if you want to use spade connectors to wire up the switch/IEC socket. I was able to cram it in there but it bent up the connectors. Hopefully none of them are making contact with others and about to short everything out when I go and plug this in. The cover isn't deep enough either if you want to use those little forked connectors under the screw. If you're just going to use bare wire under the screws you can probably get it under there fine. The hole in the front for the wires is nowhere near large enough if you're wiring 2 mosfets and a motherboard with 14ga wire, so I drilled out the vent holes and ran the wires through there. I used https://www.thingiverse.com/thing:2078936 to attach the PSU to the underside of the LACK table with the switch box positioned flush with the table leg.

Print Settings

Printer:

Anet A8

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

100%


Notes:

Hatchbox PLA
195 C / 50C

More Makes

Liked By

Top