This was quite the project, even though I scaled it to 60% it was still 12 prints not counting failures. The tall figures were too fragile at first and broke off, I had to reprint them with 5 perimeter shells. I tried first filling the figures with 3mm lead spheres, but this was not nearly enough, so I decided to use magnets. I glued a 10mm diameter, 2mm height neodymium magnet into every figure and on the bottom of every square, this was quite a bit of work... This thing consists of 148 printed parts and 96 magnets, I used up almost a whole 15g tube of super glue.