Printed in one piece with Hatchbox's white TPU
I put together the two halves in Tinkercad, as well as put the tabs in place.
I then tilted the whole thing 45 degrees up so there wouldn't be too many overhangs.
After it printed I removed all the supports, and as much stringing as I could.
I then use a lighter to make the TPU pliable, and smoothed it out with my hands.
The brown / black parts are where I put the lighter too close for too long.
If I knew how, I would make the grips a bit smaller, as I mainly use this when I play Midnight Club 3, and this grip isn't 100% comfortable.
(Since this game uses the X and Square buttons for gas and brake. For games like NFS: Most Wanted, this would be very nice)
Anet A8 with a .5mm nozzle