This is my first print (after test print) on my Anycubic i3 Mega. I printed it at 200% using MARS white PLA. It took 3:53 hours to print. The above photo is before clean-up, but cleanup will be minimal. The only problem I had was that on the final few layers there wasn't enough cooling between layers, so you'll see a slight vertical curve. I'll have to check out my settings in Simplify 3D-- maybe I can get it to slow down on the last few layers.
Renay, you did a fabulous job on modeling this! I am so delighted to have this model! I am going to paint one copy with a conductive paint then do a copper electroforming on the yantra.