Odile The Swan
Made by NiteLynr, uploaded
Exceptionally well-made model and with a little bit of care prints very nicely. Thanks Loubie :-)
Printed at 75% to fit size-wise with some other models in my display.
The model printed beautifully at 0.2 layer height with almost no stringing until the bridge at the top. My printhead clipped the head and knocked it forward and I didn't notice for a few layers. I've since discovered that Cura 2.7.0 has a z-hop function when travelling between printed parts. I repaired it by using Slic3r to get just the head & neck into an STL then sliced it using Cura with the z-hop setting of 0.5mm. This increased string a bit but it was very very fine and easy to clean. I then trimmed the broken neck off and used CA glue to fix the new one in place.