i decided to try this because i wanted a better way to wash my dishes and a spread out mist would do just that.
i printed this in black ABS with a .02 layer height. with a print surface of ABS slurry. so i had to do some sandign to get the slurry off.
for refrence i tried this in both, my kitchen and bathroom
here's the issues i saw with this
if you faucet is angled expect to get soaked.
it does not provide enough water to effectively get soap off anything (hand or dishes)
it is too tall for either of the washers in the faucets (had to use a o-ring i had on hand from an assortment of rings/washers)
had to replace the aerator in both faucets to get it to fit, so sand clogging this would be an issue.
my recommendations for this
is to make one with either a bigger hole or multiple holes in multiple angles.
make the bottom layer a thinner (like 1mm thick, in my print it came out at 1.82mm thick)
print surface: ABS Slurry
Slicer: Matter control
extruder temp: 235° C
bed temp: 110° C