I love that print! It worked after my second attempt : I used an adhesive yellow tape.
I just broke the two extreme parts of the screw thread, but it is still very usable.
Printed on Creality CR10.
PLA, noze=200°C, bed=60°C, 50% infilll
Removing the two first support pieces was quite easy. Unblocking the screw was a little tougher. I succeeded using the small support piece on the flat part of the screw, and a wrench.
Just put a bit of silicon oil and you make this wrench perfectly smooth & operational !
I used an adhesive yellow tape.