I printed one and wonder why it isn't symmetrical. When you push the two sides together, they don't meet exactly. I softened it with an airgun and corrected it.
When pushing it together, the jaws rotate a bit, because the "fingerhandles" are placed on one side. I rotated the whole tool 180 degree, so it's upside down and printed an extra and stopped the printing when just the two handle pieces were printed.
I then then glued the handle pieces onto the backside of the oexisting pieces on the tool.
I am not able to remix, so I tried this method ;-)
I know it prints best flat down but the two extra pieces for the "fingerhandle" could be printed loose with a tap and hole, for alignment when gluing.
Thank You for sharing a good idea.