Chaos Champion
Made by der_glueckspilz, uploadedDescription
the base has been scaled to 25mm x 25mm
tried it twice on the Form 2 (from Formlabs)
both took about 5 hours 20 min and needed 12ml of resin (including support structure)
-
blue resin Tough v2
layer heigth 0.050mm - Clear v3 resin (only the orange picture shows the blue one)
layer heigth 0.025mm
Print Settings
Printer Brand:
Formlabs
Printer:
Supports:
Yes
Infill:
100%
You sir, make me a happy camper seeing this! The form 2 did an amazing job! My flm printer did a terrible job so it makes me happy to finally see a good printer do him justice :)
thanks, that is very kind of you
btw which design software did you use to generate the model?
Tinkercad for 99% of it and then I copied it to MeshMixer to make the horns/spikes on the armor.