One day while printing something, my 4yo daughter came to me and said "I want a cat piggy bank!". We looked around and she like this one.
I set Cura to only use support on angles 85% and higher, which added support for the cat's left hand, nose, the roof inside the bank and the rim on the inside of the screw part for the bottom. The support for the left hand fell over while printing so there were some drooping plastic, but it cleaned up ok. The support for the nose a tiny and was no problem as was the support inside the bank. It held up the part right where the top of the slot was so it was easy to clean. The support for inside the plug hole was not so easy to clean, which causes the plug to not screw in to be flush with the bottom of the cat, but good enough.
My daughter loves her new cat bank and put all the cash she had into it! (All $1.67 of it)
Set supports for part over 85% angle only