Yes it is a little colourful, had to use my RAMPS converted Da Vinci Jr (the white parts)
and my i3 clone the red/green parts. If you look real close there is a different red and yellow in there too. So far I have only done a few test prints mostly to see how fast I can go. Its done 90mm/s so far but I think I will slow it down a bit
Thank's reply.
I catched the yellow.
Rostock Nano's nomal speed is 50mm/sec.(original Rostock too)It is 10 - 20% relatively slower from mother Printer. But deta 3D printer's Z(heght) axis speed is so fast.
Start your Engine and go time trial.
Caution:
I tryed 450mm/sec for stress test but the rodend was cracked.
Max speed is about 300mm/sec I think.(or remix rod)
Yes I have slowed it down - the 90mm/s was just me "playing" it's now back at 40mm/s
its when I also discovered a slight error on my part - it was printing mirrored but thats now sorted
Test is done.
40~50mm/sec speed is best balance.
https://www.thingiverse.com/make:483941
https://www.thingiverse.com/make:483921
Thank you for man Onemaddude to make the RostockNano.
The first are you!
It is colorful isn't it.
Looks like HotEnd part is upside down. unnn its OK.
Yes it is a little colourful, had to use my RAMPS converted Da Vinci Jr (the white parts)
and my i3 clone the red/green parts. If you look real close there is a different red and yellow in there too. So far I have only done a few test prints mostly to see how fast I can go. Its done 90mm/s so far but I think I will slow it down a bit
Thank's reply.
I catched the yellow.
Rostock Nano's nomal speed is 50mm/sec.(original Rostock too)It is 10 - 20% relatively slower from mother Printer. But deta 3D printer's Z(heght) axis speed is so fast.
Start your Engine and go time trial.
Caution:
I tryed 450mm/sec for stress test but the rodend was cracked.
Max speed is about 300mm/sec I think.(or remix rod)
Building Manual's (https://www.thingiverse.com/thing:2814219) Owl statue(https://www.thingiverse.com/thing:18218) under the half was printed 300mm/sec.
Yes I have slowed it down - the 90mm/s was just me "playing" it's now back at 40mm/s
its when I also discovered a slight error on my part - it was printing mirrored but thats now sorted