Wombot Z & Y motor bracket , included 3030 foot peg's
Made by Berniewoolf, uploadedDescription
Very nice: Much stronger than the originals which cracked. Still using PLA.
Note that the instructions in the original say that the right motor bracket and the Z motor bracket are the same, "So print 1 left & 2 right".
Actually it depends on the wiring harness. On my printer, the connector comes into the Z-motor from the other side, so I needed 2 left and 1 right.
Of course, I could have cut a cable-tie or two and re-routed the connector.
Print Settings
Printer:
Wombot Exilis
Rafts:
No
Supports:
No
Resolution:
0.1
Infill:
35%
Notes:
Very nice: Much stronger than the originals which cracked. Still using PLA.
Note that the instructions in the original say that the right motor bracket and the Z motor bracket are the same, "So print 1 left & 2 right".
Actually it depends on the wiring harness. On my printer, the connector comes into the Z-motor from the other side, so I needed 2 left and 1 right.
Of course, I could have cut a cable-tie or two and re-routed the connector.