First 5" Shuriken off of the assembly line and I was amazed to find it weighed in at an astonishing 100g's on the dot, including all the fastening hardware.
The dual colour print came out better than I hoped this is achieved by simply inserting a M600 (Filament change) code at the correct layer height. If your printer doesn't support M600 then a pause, manual filament change and resume would work just as well.
The lettering came out crisp and easy to read. there really isn't anything that needs redesigning but I will know for sure once I start installing all the electronics and do some test flights. Then I will do a full right up on assembly the same as I did for the Ultimate P230.