DO NOT MAKE OUT OF PLA I LEFT IT IN MY CAR AND IT WARPED BAD!
Short first Run video: https://www.youtube.com/watch?v=LmeovO4fiZM
Can you send motor moun file please?
This is a great project which works.
I have a few questions because I would also like to print this boat and the original designer of this project had big sealing problems :
What type of plastic have you used ?
You printed it in different parts, have you glued them together ?
Or have you done something else to make the hull waterproof ?
Thank you in advance for your answer,
I would use ABS or PETG something that is better with heat, I just used 2 part epoxy to put it together just make sure it is waterproof epoxy. For waterproofing the haul I used 3 perimeters my paint helped too I had if Profesional done where I work with hailguard paint it is kinda like bed liner. but something like plastic dip will work to.
Nice. I think I saw your vid on youtube also.