3dprintz silver PLA
You can reduce perimeters to 6 or even 4 to get less rings around the lens hole. Was this a PiCam 2? Did everything fit?
Ah, I am new to this malarkey, I didn't know perimeters was a parameter.. It's a 1.3, and everything did fit but it was so tight I had to use a vice to close it all the way - and it's never opening again..... I was a bit alarmed when the leg popped open by the bolt hole on the left hand side, but I realised it seemed designed and it clamps tightly, so it all seems good, thanks!
I had to scrape down the insides for choss a bit because it was a super tight fit, and if i'd done the runners it would have been fine I think.
Thanks for the feedback, I will loosen the tolerances.