The printing of this project went pretty well.
However the elections and software of the project is outdated and requires an experienced python programmer.
This is NOT a learning project and if you try to get support for it from adafruit you will likely get ignored and then blocked by thier tech team.
If you are manually adding supports, don't forget to put supports little triangle on the topside of the base-main.stl
The magnets are not strong enough to keep the two parts together and it will fall off your arm if you do anything to rigorous like walking.
I put duct tape on the inside on one side to help secure it and then two small pieces on the outside on the other side and it did well.