1st overnight print. Tiny bit of stringing
The line clearly visible. It's not on the stl, in the gcode etc... https://pbs.twimg.com/media/DmtkLwhWwAEg8YQ.jpg
Grr looks like gonna have to redo it... must have been 6hrs in (after this photo) and looks like something happened and there was a solid horizontal line on all two taller pieces about 50% of the way up, just the one. The rest of the print, stringing aside is fine. Looks as though several parts of the outer walls of THAT layer on the two tall parts were just not printed. The only thing holding it together was the internal infill. Total loss to know why. Will try and make it up but the display cover just parted when was cleaning it up. Not looked at the other bit yet. Will add photos. RAMPS board all ready to go into it too!