Nice, I made the medium, but I should have made the small one.
I printed the internal with TPU elastic material, it came out great. The external is white PLA.
But, but there are the following caveat with the design:
- the holes are too small and for the design it is very difficult to enlarge them, I had to use wire made of iron.
- the holes for the magnet are 7mm and not 8mm, so that do not buy the 8mm as referenced.
to print the internal and external it took about 20 hours, but it is very nice.
Now I am going to print the small one.
It is very sturdy and can hold precious glasses.
generic PLA and TPU
play printed at 60mm/s but the final layers at 40mms.
the TPU printed at 30mm/s no retraction, it came out great, but it took 11 hours.... no comment.