I created this using a MakerBot Replicator for the pieces with support (It needed very little for the knights) and an Epilog Mini for the board on 1/4" MDF. The board was then sealed with polyurethane, and I glued feet I laser cut from the same material to lift it off the table a bit. The pieces have a soft cardboard, also laser cut, that is glued to the bottom of each to prevent scuffing and promote better sliding.
The top down picture shows the scale of everything with each square being 1"
I really enjoyed making this. This is going to be a display piece for my MakerSpace room.
Red and White
See above for board materials.