Cue the Ride of the Valkyries, it's the Redacted-C!
I attached the skids to the body, then cut the body in half to print front and back. The tail I cut in half and printed each side. The rotor I printed as is with a massive amount of support. I couldn't figure out any way of cutting it apart that I'd be able to get to stick together.
My example still needs a lot of cleaning but it came together nicely and looks like a Redacted-C. The only big problem I had was the rotor broke while I was removing supports as seen in the second photo. I think that's a weak point and needs to be reinforced. The bottom part appeared to be hollow.
I'm worried the tail will fall off at some point and suggest that the peg holding it on be made longer and a little smaller - the tolerances on the peg are pretty tight for my printer and I had to shave it down to fit.
I could have used a little more support for some of the details on the roof of the main body.