Printed this to replace the DiiiCooler. Performance of the DiiiCooler was fine but I wanted more visibility and access to the hotend.
Printed at 100% scale, the funnels need a bit of encouragement but fit snuggly without being forced or cracking.
Overhang test looks normal. Temperatures were stable and didn't drop even on 100% fan. I cobbled together a connector for the two fans using jumper wires and wirenuts. The fans are held together by zipties.
It seems slightly off-center, but looks close enough for use. As mentioned in the instructions/comments I was able to move the whole cold/hotend assembly a bit to the side to get everything better centered.
0.4mm nozzle, 0.2mm layers