Had stringing due to my poor settings at the time. Cleaned up well. I should have used a brim as well.
What is the Size?
And if you remember what was the temp ?
I have issues printing the final part. I'm using CURA but i don't know how to configure it to print well the last part. I'm adjusting the "Minimum layer time" at 15s and the "Minimun speed" at 5mm/s with "Lift head" enabled. Could you give me some advice please? Thank you.
Hey. What is the issue you're having, does it break off or something? Have you tried enabling z hop under travel?