Printed on an AnetA8 with supports (at bottom of the body) and 0.1mm layer hight (no supports for the wings) and no additional sanding afterwards.
To give the snitch some realistic (non plastic) feeling, I drilled a hole in the bottom and filled it with sand.
To make the stand, a simple 1.5mm copper wire with black insulation was used. To make the snitch removable, a short piece of the cable sleeve was glued into the body of the snitch, this makes for a snug fit and allows repeated removal and easy putting it back in place.
The wings were brought into shape after printing using a hair dryer.
The dome and base are from a local craft-store, as they had some defects i spray-painted the base black and glued the Hogwarts insignia over the major defects.
The front shield is etched in copper and the grooves highlighted with some spray paint.
This is a great model and makes for a very lovely present for any Harry Potter fan.