This is an awesome model.
For the print I have increased the height to 130mm.
Also I created a remix to print the model without supports.
Good execution. Thank you.
I think that we have the same printer.
What do you mean with adaptive resolution?
I am using Cura 3.6 for slizing.
Under experimental is a function called "Use adaptive layers".
Depending on the slope of a model the system changes the layer thickness.
This gives a better finish on the shallower slopes without increasing the print time dramatically.
I will give a try.
Normally I print at 0.1 resolution for better results expecially when i'm Printing busts or action figures but the print time is impossible :)
I wish you good luck.
I have uploaded the remix of your model. https://www.thingiverse.com/thing:3344806
Also created a pedistal for it. Check it out: https://www.thingiverse.com/thing:3345152