Friday Filament PLA
This is a great pose both for display and printing. I'll have to dust off my Wanhao D7 and give this a try in Monocure Clear.
I am experimenting with Meshmixer tree supports on FDM prints - unfortunately in this case they ruined the fine detail on the back.
There are few issues with the thin clothing not printing properly that created a tiny hole in the print. I use a dremel and burs to clean up prints, so it is possible to close the hole by using friction from the bit to heat the plastic and smoothing it over. Primer covers many sins!
I am a Kickstarter backer of desktophero3d.com. I very much approve of and appreciate the work Andrew is putting into this project.