Thank you for the Rick and Morty models!
I printed Morty in two pieces. My first couple of prints started coming unstuck when printing Morty's chin. So I chopped the model and created a bust model to print. Joined the pieces together by melting the pla on an iron for few seconds and then pressed together. Worked great! These two Mortys are Eye Patch Morty and Tan Morty.
For Rick's print, I chopped the model into three pieces. Cut a bust model, cut his right arm with flask, and then neck down. I used super glue and drywall filler to join the pieces because that's what I had in my toolbox. The filler was used because my pieces had some gaps when joined after sanding. Will probably try a different method next time.
Printed with raft because the Morty prints were coming unstuck at about 70% complete. Printed Rick's bust with raft and his neck down was printed upside with a raft. His arm printed with no raft.