A very messy 300x300 D-Bot, using a 200x200 bed from the printer it was made from.
Printed on Folgertech Prusa i3 clone in EconoFil 1.75mm Gray PLA, printing replacement parts in EconoFil 1.75mm White PETG.
Parts are printed at 0.2mm, no supports,
Run through Duet 2 Maestro. RAMPS is too underpowered for proper CoreXY motion, heavily suggest the Maestro.
PETG prints best at 20-40mm speed, capable of printing PLA at 70mm with no major loss of quality.
Z Leadscrew Bracket for hardware kit