I printed Bender on my Ender!
Printed at 100% scale. It took about 13hrs total print time.
Used super glue on hands,and 5min epoxy on larger areas.
Sliced in Cura 3.6.
Printed at 235c nozzle,45c bed,30mm/sec on all speeds except first layer.
3 shells,6 top and bottom layers(used fewer on hands).
This was my first attempt at printing a large hollow model with zero infill. I was surprised that it worked so well since the Ender 2 has no dedicated parts cooling fan. I used infill in the legs and hands since I was experimenting a bit,but the large structures are completely hollow.
Very fun model!
Update 3-25-19: Just added a tiny version at 25% scale and 0.12 layer height. Took a little over 1 hr. The hands were teensy and I almost lost one lol.
Maker Geeks PLA
0%(except for legs and hands)
The top layers on the torso did close up completely by about the 4th layer. I used 6 to be sure,and it worked out well. The photos show the first two top layers laying down. No gaps anywhere on the finished print,although there was bit of an indentation on the back of one butt cheek. A few strings and blobs to clean up,but nothing major. I deliberately put the z seam on the back.