The mountbase :
Ok this one was a hard print for me, but finally i made it !
3 attemps to success
Thanks for the model
It seems to be easy at first sight but honestly it's a trap :P !!!
- It's thin
- All the bottom until the hole is very easy, but once you reach the holes it's another story. The fact is, its make in my opinion, the structure more fragile
- The 4 hooks have a small support too
For the print i have to put my temp @220°C (i think the PLA become a bit stronger when it cooldowns)
I reduce the layer from 0.2 to 0.16, it's not a lot, but for me it was effective
I reduce the speed from 60 to 50 then 50 to 40 mm/s
For the assembly, maybe you have to work some sanding for the holes of the mountbase
When you have to put together, it's very tight so do it gently.
I recommend to put them together then screw to your wall.