My new bedside lamp, i really like it! Complete lamp took about 25h to print. I had to reprint the base (12h) 2 times because of underextrusion in the last 1,5 cm :) Maybe the filament was too cheap (nozzle clog several times), or the angle of the PTFE bowden tube was too steep at the top, causing too much friction for the filament above 22cm (Ender 3 = 25cm height max). The white shade of the lamp (printed in vase mode) went perfect although it has 24cm height. I set the (material)flow for the vase mode to 125% (at the printer directly) from the beginning, so the shade has a sligthly sturdier wall (this trick can be used for all vase mode prints). I had to cut the middle tube for the cable in 2 halfs (more precisely set the z-position in Cura to minus 134'ish cm, then turn arround the part 180 degree and do the same again) and print it upright with a 8mm brim. If there are any more questions about the print, feel free to send me pm.
no-name, Kaisertech PLA