Printed on a "fixed" AnetA2. This is literally the ONLY watch stand I have printed that works, I must have printed half a dozen different designs and all failed in one way or another.
There are 3 failure modes. Not holding the charger in place, not holding the watch in place or holding both but not aligning to charge.
This stand worked perfectly. The charger and cable neatly fixed into place without issue, it was a perfect fit and nothing popped out or fell out. The watch sat perfectly in the stand and didn't wobble or fall off or make the stand topple over. It charged first time, perfectly. No alignment issues at all.
THIS IS IT. If you have the same watch as me in the photo, you should have no trouble using this stand if it prints correctly!
I only used 15% infill for the whole print against the makers instructions. I just used a sticky pad to hold it in place on the table but honestly you don't even need that. It's printed in Glow In The Dark blue PLA, just to make putting my watch onto it after I turn off the light easier :)
ebay special PLA
I got a bit of stringing but it was easy to clean up and didn't really cause any issues. A sticky or nonslip pad on the bottom might help it to not slide around but even without that it's the most stable watch stand i've printed.