I printed this model scaled down to 40%! Took a few prints, and I used the support blocker in CURA to omit certain areas of support that wasn't needed. Wasn't easy removing support around the paws without breaking them as seen in one of the orange prints. Ironically, I could not get it to print properly at that scale on my CR10 mini. They printed fine on the Monoprice Delta mini with a 0.4mm nozzle at 0.12mm layer height. All models were printed in ABS and then vapor smoothed with Acetone. I use a double boiler method by putting the model inside an old 1 quart pot with lid and I float the pot in a bigger pot filled with hot tap water for 22 minutes. Can take an hour or more if you don't heat up the Acetone. 1/2 to 3/4 cup of Acetone works for me. Smoothing continues for a few minutes after you remove it, so not overdoing it is key. For small prints, I simply use an old, cleaned out can of cat food as a stand that I drilled a bunch of holes into. I cover it with aluminum foil and depending on the size of the print, I poke holes so that the vapor can come up from under the can and reach the model.
Amazon, Hatchbox ABS
Red and Black