Recorder V2.3 (new Mouthpiece)
Made by perldog007, uploaded
Description
Almost! New maker and mechanically "challenged".
This printed fine twice on Creality ender 3 with generic cheap red PLA using a brim. .2 resolution and 20% infill.
Both times I broke the fittings due to slow learning and gumby like dexterity. I'm pretty sure third time is a charm.
Wonderful design.
Print Settings
Printer Brand:
Printer:
Supports:
No
Resolution:
.2
Infill:
20%
Notes:
Wonderful design,
Getting closer!! on attempt number three we got the first joint right but sanded the two smaller ones too much in circumference before I figured out I had to take some length off. The two sections, mouthpiece and first section were amazingly close to perfect notes according to gstrings tuner. Very impressed, fourth time I might get it right :D
Make sure to sand those fittings.
The mouthpiece is very strong, gave great tone. I'll have together tomorrow.
right on, using an emory board. I just got stupid trying to fit them too tight and snapped the connector to the mouthpiece trying to take them apart for further sanding. I'll get there. I have a plan for tomorrow ;)