Came out almost flawlessly apart from slight stringing which I fixed. High notes play really nice and low notes play really nice but they are in a different scale. I can get one scale by not covering anything up until I cover left side of the top holes and then it switches to different scale and I can play the low notes.
I can play the "low note scale" almost all the way up but I have to blow harder and harder to get the higher notes. I can also play the "high scale" all the way up but at the lowest end I have to blow really softly to get it.
My print turned out so flawless that I'm surprised no-one else has mentioned this problem.
Clas Ohlson PLA
Printed at 25mm/s
I minimized supports by printing in the same orientation as it is in the picture so it only needed supports in the bottom arch.