card10 case (cccamp 2019 badge)
Made by alxlo, uploadedDescription
This is a really nice design. Thank you!
The top part was printed with 0.15 mm layer height with the first two layers in DAS FILAMENT glow-in-the-dark PLA, other layers with Fillamentum PLA Extrafill "Luminous Orange". The two bottom bracelet covers with WillowFlex "Apricot Orange".
The concave areas in the top part caused slight but acceptable warping. The actuators for the buttons needed a bit of rework after print as they collided with the case and could not be pressed deep enough reach the switches. Some holes for better visibility of the status LED would also be nice. Otherwise this is a fine design and I'm happy you gave this to the community.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.15 mm
Infill:
100%
Thank you for your feedback. I'm happy to hear that my design is useful :) Which status LED do you mean? (So I can add it to the model)
Look at the bottom side of the top board (aka Harmonic Board). There are 4 side facing RGB LEDs, labeled LED1 to LED4. The upper left (seen from top when wearing the card10) is the mood status LED which can be toggled with the "Personal State" App. Of course, holes for the other 3 LEDS might be a good idea as well.
I've updated the side-cover. Maybe this change is an improvement...
This is very probably an improvement. Thank you!