nozzle temp: 215C
Bed temp: 60C
Bed Type: Creality Glass
Approx print Time: 48hrs
Filament Usage: Approx 442g - 148.22m (Per CURA)
The only issue I had was with the underside of the roofs overhang. No support was used. Left it stringy and squiggled with filament.
If I could do again, I'd use Cura and set the roof and base to 100% infill and do 20% infill on the mid section.
My solution for surfacing the roof under side was to clip off loose strands, use putty knife to scrape down to simi-level surface, then use wood putty to smooth out. Then prime and paint.
All in All, an awesome project!
Props to the Original Designer!
My first major print and glad to have it as my current showcase item!