you have made a good work, but … because there always is a "but" ^^
is there a possibility to have the model "Case_Rear_With_Nuts" without the GPIO hole or may be without the GPIO hole "and" its pre-cut location with dotteds, like that, if a day we need to use it then I should have just to cut the dotteds
thanks a lot.
Thanks. I modified the nut pocket depth to have better engagement of the nut to the 25 mm screw.
I like the painting of the logo.
That should solve it. I may print that one as I have been thinking of doing the other half white or green anyways. I recently discovered oil paint pens and that makes painting 3D printed objects so easy.
I'll have to check out the pens. I've been using Testors paints. I guess that's a hold over from building plastic models. Pens would be so much easier.