vary pla, pla+ for skin
10 to 40 (40 was by accident on another in between print!
printed great!!!, if you have to tight of a first layer (squish) you will get a little extra on the parts that touch plate and have to scrape a bit with a good knife, not an issue at all for any of the designs(i did all the Peanuts he has) as the parts all insert into other parts, after discovering this I did adjust my Z offset a bit to get less squish but still good adhesion, as I see I wasn't dialed in very well, so this print actually made my printer that much more on point with prints!!!
lucy turned out great!!!
I did break her socks due to the "squish" on legs, but instead of reprinting I just glued the top piece of socks to leg, and actually i think that was bc I put legs into socks upside down at first.... still looks great, you can see a tiny gap but next print I will fix, if I do reprint them!!!
which I am sure friends will beg for the set!!!
also found another designer made the Christmas tree from peanuts!!! going to make that as well!!!, soooo cool!!!!!!!