Thanks to Dave for sharing the frame! In support I'm sharing these models for you guys.
Matek SAM-M8Q GPS trunk mount sits below the prop line. Print the file vertically with full support. The GPS module has a snug fit while the standoff mounts are tighter. I recommended heating the TPU a bit before pushing in the standoffs.
Shorter camera mounts for micro FPV cams. These help keep the front frame/standoffs from being in the HD image. I'm using a Runcam Split V3 here.
Micro LR frame
Rcinpower 1207 5k kv
HGLRC 16mm stack
TBS Nano RX
2s and 3s
Quad is dry weighted at 140 grams
I'm currently getting about 11 minutes flight time from a 950mah 2s lipo. I'm also battling some low throttle oscillation, so first trying to nail down the tune before sending it.
RIP THESE PRINTS AND GET 'EM AIRBORNE DUDES!
.2700 and .3000 both work great
Sainsmart TPU TPU