This is my build of the MK3S camera swivel mount, printed in green ASA to make it standout, but also because the IR sources get a bit hot and would melt PLA, waiting to see how well the ASA does. Also included a screenshot of the camera view from Octopi at its default settings. Would probably like the view from the camera to be a little higher but can sort that with a longer screw and a spacer, although it does give a nice view of the nozzle where it is. Mounting the Raspberry PI off the arm is a temporary measure until a longer ribbon cable is delivered, went mad and got a 100 CM length cable which should give me plenty of mounting options.
Technology Outlet ASA
Printed at 265/110 with no fan as I don't have an enclosure and ASA really needs one as it has a tendency to lift and will even split apart on taller prints. Recommended temperature is 235 but I want stronger prints than that gives. Needed to reprint the back of the housing with a brim as it had lifted and deformed at one end, thankfully didn't come detached as I was printing all parts at once.