AMZ3D PLA 1.75
Green, red and yellow
Used 15% infill on the box bottom and lid, 100% for everything else.
Only used supports on the lid (for the bar that the lock hooks over) and the first ribbon (support printed around the keyhole). Used a brim for the key.
Printed on a Prusa Mini (I chose “clone” as the Mini isn’t shown in the list to choose from).
One thing to note on nozzle temperature when using the AMZ3D filament. The filaments state 180-210 degrees but I was forever having failures, clogging in the nozzle, stringing, not sticking to the heat bed etc. I now always use 230 degrees and have had a 100% success rate on prints ever since.