Hero Me Gen5 Master Suite for Creality & clones|E3DV6|OEM|MicroSwiss|Volcano|Mosquito|Hot End|4020 Fan|5015 Fan|CR10|Ender3|Ender5|CR10SPro and more
Made by Liviuf, uploaded
Thingiview
Description
Hero Me Gen5 for Printermod's MDD - Ender 3 Pro with e3d-V6 and e3d-Titan + BlTouch
ABL
- BLTouch_Wing_Compact - cracked after install
- BLTouch_Slider_Compact
I got issues with alignment of bltouch using the compact version, its not at aligned with bed at 90 degree, slightly tilted to the left side.
Ducts:
- 2x 5015_Lightweight_Duct_Forward its a little messy to align them both :)
MDD DD Adapter:
- PM_Titan_RH_Adapter_1
MDD Gantry Adapter:
- PM_CR-Ender_E3D_Gantry_Adapter_5B
- PM_Gantry_Clip_5
Hotend:
- Hero_Me_Gen5_Base_3
- HMG5_E3D_V6-Clone_Collar - cracked after install
All parts where printed at 0.2mm, 40 speed, 210c, infill 50% with exception of MDD DD Adapter and MDD Gantry Adapter that was printed with 85% infill.
Print Settings
Printer Brand:
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
50% - 85%
Hi, which version of the compact BLTouch wing and slider did you use, those don't look like the most recent design? Here is the print orientation I was using for those parts (I am planning on updating the STL files in Mediaman's collection with my recommended orientations, as the ones currently there are not always optimum)
We will also be doing an updated version of the forward ducts, which might be useful for you.
Can you send me pictures showing the alignment problem with the BLTouch? I am hoping that changing your print orientation will help with that, but the BLTouch looks aligned in the pictures
Bltouch wing and slider dated 12 June. They are identical with yours.
MD5 (BLTouch_Slider_Compact.stl) = 77625ea449e9a20d4c3013e0240cdb10
MD5 (gen5-bltouch-sliderB.stl) = 77625ea449e9a20d4c3013e0240cdb10
MD5 (BLTouch_Wing_Compact.stl) = 746f60054b570e78c1472211a74b830b
MD5 (gen5-bltouch-baseB.stl) = 746f60054b570e78c1472211a74b830b
Sadly is hard to get the tilt in picture. Is not that obvious its a small tilt but ill try using a macro tomorrow with the pin on the bed surface and I will remove the front left duct to take a pic. in hope that will be something visible.
I suspect it has something to do with the orientation of the base part, that will almost certainly help with the cracking you experienced.
On a side note, it looks like the left side fan isn't quite seated in the opening of the duct properly
I am gonna see when I do the next print, tomorrow too. I hope it was just my printer and me doing a lame job. Regarding the alignment, I hope that its the bltouch mount and not the entire system, like the gantry adapter. I am taking in consideration that a poor calibrated print can mess the alignment, however the nozzle looks aligned compared with the bltouch.
Anyway, you guys did a wonderfull job here! Thanks!