Didn't use a high resolution :)
The silicon damper mounting holes were printed in a unusual way, wonder if it was the slicer or the 3D model.
I haven't had any problems with the 3D model in the past, but if you find an issue I can fix, just let me know. For the dampeners, intensewalkera has created some nice 3D printable moulds here:
Thx for the reply, I didn't check back on this : )
I think it was the slicer anyhow, I used the kiss slicer, there were some caps I remember
I discontinued the project, now working on some other epic open source project : ) www.brain-duino.com
Thx again for sharing this awesome thing, was very useful!