Printed with Anycubic i3 Mega-S:
Filament: TINMORRY PLA Filament 1.75mm Black
Temperature: 205 °C
Heatbed: 60 °C
Print speed: 30 mm/s
Retract: 4 mm (very important because there are many 'bridges')
Retract speed: 40 mm/s
Resolution: 0.2 mm
Infill: 100 %
Print time: 2:57 hours
The fan must run up to 40% from the beginning.
Because the faceplates were difficult to remove, I heated up the heatbed up to 80 degrees and then let it cool down.
I glued orange paper (karton) underneath and attach the faceplates with double sided tape.