Made this for a friends ATN X-Sight night vision scope cover. You will need a paper clip or piece of wire about .040" to connect the three pieces. The holes are tight so you will have to drive the pins in. Go slow when driving in the pins. You do not need any support to print these pieces.

I had to do some prints for a student display. I made a few tweaks to some so I'm posting here so they can be used by others if needed. I included the following emblems:

Avengers
Thor
Hulk
Spiderman
Batman
Superman
Wonder Woman
Hawkeye
Captain America
Flash
Ironman

A tab to screw to the back of a European Mount deer mount in order to hang on the wall.

I built this to mount my XM Satellite radio receiver in my 2007 Toyota Tacoma. It replaces my broken cup divider thing and positions the radio in a convenient place. I can still use the cup holder for can drinks and bottled drinks but not the big extra large belly washer cups.

The famous Peg Puzzle

The last picture is of the final product turned on a lathe

Built to hold my Logitech THX controller and mount on the wall.

Made these to replace the factory foot on my Logitech THX speakers so I could mount them on the wall beside my monitor

I hate the way Makerware handles support so I added my own.

Took original and trimmed it up a bit and split in half so that it would print better for me.

Took it one step further and sliced it in to thirds

I took and remixed the original mesh so that all the internal detail can be better illustrated.

This is also bundled with my adjustable rifle rest but could be used for other things as well so I thought it should be offered by itself as well. It is use to make a knurled knob with a 1/4" bolt/stud epoxied in.

I modified my previous rest so that it is adjustable for wind-age. To complete you will need 1/4" all thread rod, two 1/4" locking nuts, 1 1/4" coupling nut, and some epoxy.

The nut would need to be purchased and epoxied to the thumb wheel. I have a huge bevel to hold the epoxy or what ever adhesive you choose. This is not a press fit and requires adhesive. I like the putty type stuff that comes in a plastic tube that you cut off what you need then and kneed together that hardens extremely hard. This was mad for my rifle rest front elevation adjustment to make it easier to turn.

I added a stand to this fighter jet

Front Rifle Rest

Bracket allows you to secure a second hard drive under the first hard drive. The HP3400 and some other models do not have a means to install a second hard drive. This solved the issue for me.