Loading
tofuji

Round Clock

by tofuji Sep 6, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

Maybe me turned out ok, other than I need to paint it better
I had the hands already so I used them for now

Comments deleted.

Love this clock but can't figure out how to put it together. Could you tell me where to start? I printed this last night with Translucent Purple PLA and it was perfect. Have ordered some clock mechanisms. I really love this clock. Liked it even more after printing the numbers. They look nice and different.

Thanks.
You can start from the 2 parts.

  1. Take ftont face and body parts, and adhere them by instant adhesive (or something good one for PLA).
  2. Place jig on a table, then place center part to center.
  3. Take part "3", and set it at right. After confirming there is no burr, adhere the part "3" to center.
  4. Do same thing on part "6", "9" and "12".
  5. Insert clock unit to the center part from backside, and lock it up by a nut.
  6. After removing barr from center cap, set it to the center part by double sided tape, if necessary.
  7. After removieng barr form 2 arrows (you may need taper reamer to do this), set them to shaft of the clock unit.
  8. Adjust gaps of hour arrow. If it is too short to center parts, it should stuck in the numbers,
    and if it is too short to min. arrow, it also stuck in min. arrow.
  9. Set AA battery, that is all.

Also I took a video, but some sequences are wrong. please refer to above order.
http://www.11moon.com/Thingiverse/Round_Clock/Assemble_Round_Clock.mp4