A wave shaped business card holder that I created - its simple as anything to make, and should snap fit, but a little bit of glue might be helpful.
Very nice for those who want something a little more interesting for their business card holders.
Design is intended to be lasercut from 3mm perspex or MDF (Perspex recommended). The red lines in the file are cutting lines, the black shapes are etchings.
When you pull the pieces from your sheet, you want to keep one of the pieces of perspex/MDF that comes out of the slots on the wave pieces, as that is used as a stopper on the front of the base to stop the cards from sliding off. This is the only part of the design that needs glue, and it doesn't take much at all.